This is the front mount transmission cradle for the Axial SCX10 II kit so you can install the motor, transmission, and transfer case in your Axial SCX10-II (SCX10-2) in a forward-facing orientation rather than facing backwards. In addition to looking much better, the forward-facing orientation helps add forward weight bias for better traction on steep climbs. We include one side plate spacer for better clearance if you run the stock side plate with molded-in receiver box. For a complete, bolt-on solution, you will also need the BowHouse RC SCX10 II HD battery tray. You will also need to change driveshaft lengths. The kit has all of the parts needed to adjust stock driveshaft lengths. In front, we used AX31114 parts 5 and 7 for the female ends and the male middle piece that had a part number 3 with no tree number in our kit. In the rear, we used AX31114 5 and 6 for the female ends and AX 31397 for the male (originally from the front).
IMPORTANT NOTE: This cradle is for the transmission included in the Cherokee XJ kit and UMG10 versions of the SCX10 II and does NOT work with the 3-gear transmissions included in the Scale Builders Kit and other RTR versions of the SCX10 II.
ReviewsKellieEasy fitment and did what I neededTAKAFUMI NODA
great fitAttached to axial scx10ii UMG10. You can easily flip the transmission. There was no problem with the hardness of the resin. By using this, the weight distribution became closer to the crawler. Maneuvering became easier without rolling over. It's a very nice product.Paul
SCX10-II UMG10 Forward-facing 'Flipped 180' Transmission Cross-member MountThis may be older school...but my custom extended UMG10 is all metal including the transmission & Motor assembly. For anyone wanting to do this GREAT mod, then all that's needed is to flip the metal skid plate and also flip the transmission assembly, All the same hardware is reused, no mods are needed except for the addition to reinforce the now appropriately forward-facing transmission using this great little lower transmission spur-gear casing cross-member.....everything just bolts right up! LOOKS FANTASTIC AND STRONG. Highly recommended!Emmanuel Ramirez
Scx10.ii front motor cradleGreat service, awesome products! Definitely worth the buyGary
Works greatGreat quality will definitely buy from you guys again thanksSteve Maizey
scx10.2 trans flip cross memberLooks good fits great, honestly what more could you ask for ? A+
Leave a Review
DetailsCurrent Stock:SKU: BSX-0012SUPC:Width: 3.0 (in)Height: 1.0 (in)Depth: 6.0 (in)