N2R High Clearance Skid for HPI Venture

(1 review) Write a Review

We love the HPI Venture, but let's be honest. It hangs on everything. But don't worry...we're here to help. Our updated N2R High Clearance Skid for HPI Venture gets rid of that unsightly and inconvenient hump under the stock skid, improving ground clearance by over 3mm and allowing the skid to, well, skid! This bolt-on replacement for the stock skid is printed in high-strength nylon and does not require any additional modifications to work.

Package includes:

  • 1x skid
  • 10x M3 washers
  • 1x M3x20 BHCS


Installation notes

  • Reuse all 4 stock M3x10mm FH screws to attach transfer case to skid
  • Reuse 4x M3x15mm BHCS screws from stock lower link mounts to attach BowHouse skid at center chassis mount locations instead of stock M3x18mm BHCS screws
  • Reuse 4x stock M3x18mm BHCS taken from center chassis mount locations to attach lower links to new skid
  • Reuse 2x M3x20mm BHCS for rear upper links
  • Switch front upper link to M3x20mm BHCS
  • Use M3 washers or shims as needed to eliminate play at link mounts
  • If using BowHouse RC Low CG Battery Tray, use 2x M3x25mm or longer screws at center rear screws through chassis (not supplied)


For an even higher resolution version of this part, you can purchase the SLS nylon version from our Shapeways store:





1 Review Hide Reviews Show Reviews

  • 3

    Posted by Unknown on Feb 27th 2019

    Good product but I felt the area in links could have been tighter. Had to use shims to avoid slop in links. Print did not seem equal on all areas. Really grainy in areas that will need sanded.